Classic Jack-o-Lantern Face pumpkin stencil, printable black and white pumpkin face template
Classic Jack-o-Lantern Face design carved into a pumpkin and glowing with candlelight

Printable stencil · carved and lit

Free · Easy · PDF

Classic Jack-o-Lantern Face Pumpkin Stencil

A free printable pumpkin stencil of a classic jack-o-lantern face with triangle eyes, triangle nose and a wide grin with two square teeth.

Save to Pinterest
Carve it on my pumpkin
Make this from your own photo →Turn your pet or family into a stencil like this. First AI stencil free.
Difficulty
Easy
Carving time
20–40 minutes
Best pumpkin
Any size; small 6" works
Floating pieces bridged
0
Theme
Pumpkin Face
License
Free for personal use

About the classic jack-o-lantern face stencil

This is the face most people picture when they hear jack-o-lantern: two triangle eyes, a triangle nose and a wide grin with two square teeth left standing. It is the oldest pumpkin look there is, and it still reads from across the street better than almost anything else.

The design has no floating pieces at all, so there are no bridges to protect. The two teeth are simply tabs of skin that hang down from the top lip of the grin. Keep them at least as wide as your thumb and the face will survive a week on the porch.

Tips for this design

  • Point the eye triangles slightly toward the nose for a friendlier look, away from it for a meaner one.
  • A round, evenly orange pumpkin shows this design at its best.
  • If a tooth cracks, pin it back with a toothpick from behind.

Carving the classic jack-o-lantern face stencil

The weak point of this face is the strip of skin above the grin. It carries the weight of the whole top half, so the mouth should not be wider than about two thirds of the pumpkin. The triangles are straightforward: saw each side as one straight cut and lift the piece out from the inside rather than pushing it in, which keeps the edges crisp.

Cut the nose first, then both eyes, then the grin, working from the middle of the mouth toward the corners so the teeth are cut last. Full transfer guide.

Common mistakes

  • Cutting the teeth too narrow, so they snap when the mouth piece is pushed out.
  • Placing the face too low, where the pumpkin curves away and the grin stretches.
  • Leaving the wall thick, so the triangles glow dimly at the edges.

Make it yours

Want the classic look with a twist? Carve this face on one pumpkin and your dog on the next with an AI pet stencil, or upload a photo of your own pumpkin to see exactly how big the triangles should be on it before you start.

Classic Jack-o-Lantern Face stencil questions

Is the classic jack-o-lantern face good for a first carve?

Yes. It has four openings and no bridges, so it is the easiest design in the gallery and takes 15 to 25 minutes.

What size should I print it?

Any size works. Small fits a 6 inch pumpkin; Large on a 10 inch pumpkin gives a bold porch face.

How far apart should the triangle eyes be?

About one eye width apart. The PDF already spaces them that way for the size you print.

Can I carve it on the back of the pumpkin instead?

Yes. Pick the smoothest, most symmetrical side; that is often the back.

Why use a stencil for such a simple face?

A stencil keeps the eyes level and the same size, which is what makes a classic face look neat instead of lopsided.

More stencils like this

Pumpkin face stencils